Jump to content
Welcome to our new Citrix community!

Netscaler VPX 12 and brocade switch - Failover


Recommended Posts

Hi All,

 

I need some assistance with Citrix VPX 12. 

 

Setup:

++++

We have a HA setup of VPX version 12 that uses GARP to determine on who is the active unit. 

The Netscaler would just get into a hung state and upon investigating the TAC advised to change the NIC from E1000 to VMXNET3.

We updated the NIC and there were no more drops however a new issue arise where the failover was no longer working. 

When we fail-over the arp entry on the switch does not get refreshed. 

Not sure what may be wrong and has anyone encountered similar issue and what could the issue be. 

 

TIA. 

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...